How does the place that wooden moulding joins have seam to handle

If it is a moulding and the seam of the door cover, dot transparent glass glue. If it is a door core board, then only natural wood mouldings to find a beautician.

Wooden door mouldings to not bend, must pay attention to:

1. The solid wood base material must be dried. The moisture content of the dried European wood moulding is about 15% in the south and 13% in the north;

2. The panel of the moulding, such as wood moulding, is made of density board or plywood. It must be made of thicker materials, generally with a thickness of over 3.7mm.

3. When applying glue to compound and nail ears, the mouldings must be shaped before the glue dries;

4. The newly made mouldings should be laid flat to ensure that the glue is completely dry before the shaping;

5. 2~3 3-4mm deep anti-deformation grooves are opened on the back of moulding solid wood substrate.

Type of wooden moulding is more in our country, wooden moulding chooses qualitative hard, woodiness finer, wear-resisting, corrosion-resisting, do not split, cut face is lubricated, treatment property is good, paintwork coloring sex is good, adhesion sex is good, nail force is strong lumber, after passing manufacturer of natural wood moulding dry processing, with machine treatment or craft treatment and become.

1. Sealing edges at the joints of different levels on the wall; Sealing of joints of different materials on the wall, edge pressing of dado,

2, a variety of decorative surfaces, doors and furniture appearance of the edge moulding and modeling moulding.

3. Sealing edge of the joint of ceiling, wall and cylinder.

4. Modeling moulding of ceiling plane.

The appearance of wooden mouldings should be lubricated, sharp edges and edges of the pen is clear, there should be no distortion and oblique bending phenomenon. The technical requirements of wood mouldings have two objectives: moisture content and formaldehyde emission:

1. Moisture content: the moisture content of solid wood mouldings and finger joint wood mouldings before application shall not be less than 7%, and shall not be greater than the local balance moisture content of wood-based boards in all regions of China. The moisture content of wood-based boards before application shall conform to the corresponding requirements of wood-based boards.

2. Formaldehyde release amount: the formaldehyde release amount shall be measured for the mouldings using finger-joint wood, wood-based board and wood-plastic composite wood as the base material, and the limited value shall be no more than 1.5mg/L.