Selection of wood mouldings and method of closing
Feb 02, 2019
Adornment wood moulding can make the bedroom abound administrative levels to feel and artistic beauty. Commonly used wood moulding has moulding of panel moulding, waist, inside horn, smallpox horn moulding (top horn moulding), kick a foot moulding, semicircle moulding to wait. The wood moulding that the supply on manufacturer of market wood moulding still is divided for did not go up lacquer and already go up two kinds of lacquer. Wooden moulding is in decorating empty natural wood moulding to rise between "rise, turn, face, close, cent" action, natural and fluent attribute, get clever reflect. No matter be the moulding of panel moulding, waist moulding, inside horn moulding, still be smallpox horn moulding, kicking a foot moulding to wait to see wind bone in protuberant, between sunken show gentle beauty.
When selecting the wood moulding, the following points should be noted:
(1) the processing quality of wood moulding is the key to the effect of decorative European wood moulding. Should choose smooth, smooth, smooth, no burr, no knife marks, no insect eye scar. Should pay attention to the mouldingar pattern is clear, the depth of processing is consistent.
(2) according to the decoration of the moulding, filling moulding needs to be selected, or thick, or fine.
(3) the use of wood moulding should not be too complex, should pay attention to practical, beautiful, reasonable.
(4) because of the material and selection, ash panel should pressure ash wood moulding, yellow and white color panel with white wood or linden wood moulding, deep red panel can choose red beech wood moulding, indoor ceiling with ordinary board veneer, linden wood moulding can be selected.
Use wood moulding to close a mouth to be able to enrich adornment face modelling to make adornment face more perfect. Place of receive a mouth is to be between the wall and top commonly, dado and skirting board between, board and board between, between different facing material and place of horn of Yin and Yang. Receive material to should choose the wooden moulding with same as facing material, can choose wider wooden horn moulding between wall and top (gesso moulding also is ok).
Convex circular mouldings (or metal mouldings) can be used between different finishes. Wood mouldings are usually fixed with adhesive, and then nail yuan nails or gun nails. Yuan nail nail head to play flat, the position of the nail should be in the groove of the wood moulding or the side of the back moulding of sight. When the height of semicircular batten is less than 1.6m, it is pinned at the lower part of the circular moulding; When larger than 1.7m, nail on the upper part of the circle moulding.
